How it΄s done:
- Remove the locking ring and the battery tray.
- Unscrew the emitter with pipe tongs (lay a rubber mat underneath the material to protect it from damage).
Foto 1
- Detach the golden metal blank (activatorbox) with a thin item carefully.
Foto 2
- Detach the screws underneath the blank and remove the whole box!
Foto 3
- Desolder the wires from the shifter and press them into the hilt piece.
Foto 4
- The thread the emitter was screwed on contains a pin.
This pin is to be beaten through the hilt peace with a sledge and a blunt nail.
Foto 5
- Detach the thin black fixture from the battery tray (is not necessary anymore).
Unfasten it with a thin item (srewdriver) in several places; afterwards pull with a pliers and unscrew it simultaneously.
Foto 6
- Unplug the frame along with the electronics from the hilt downwards (towards the battery case).
Foto 6
- Knock out both (steel) pins in this frame with a sledge and a nail as well and detach the blade holder/blade.
Foto 7
- Saw apart the electronic block on the splice clean and even.
Foto 7
- Now one can release the connector that is attached to the LED bar.
Foto 8
Now the dismounting is completed.
Have fun with tinkering, your Team Saberproject!
|
Das Lichtschwert
···