Luke Skywalker ROTJ - Blade-Holder-Conversion Page 2

Luke Skywalker ROTJ - Blade-Holder-Conversion Page 2

Twist the emiter on the brown element to earmark the exact lenght for the pipe.
The pipe must be flushed with the emiter.
Mark the pipe at this point and cut it off.

After this pull out the pipe and adapt it to the blade because it is a little bit thicker than the inner diameter of the pipe. Abrade is from the inside so that the blade can be pulled in with a bit exertion.
After a test, remove the blade (it must be pulled out with power out of the pipe) and abrade/cut two semicircle deepenings at the upper end into the pipe. These are the complements for the case of the soundmodule and anticipate that the construction contorts, when it will be reassembled later.

Now screw the emitter on the brown element and press the tube into it until the arrester. On the lower side of the screw thread there is a small notch. Drill a little hole into the tube where the black cotter-pin is situated normaly. Adhere it with the tube, so that it is fixed.

<----Page 1 Page 3---->

[ Back ]